Toyota 2 button key shell for Corolla Hilux Hiace Rav 4 Tarago Yaris and more

This newer triangle shape 2nd generation remote key is used with lots of different Toyota models as shown below in the list. This one has a TOY 43 key profile which is by far the most commonly used Toyota key blade profile.

There is also a 3 button and a few differently configured 4 button versions of this key shell. We try to stock all the most common variations. 

This shape key shell has been used with the following Toyota models:

Don't replace your entire remote key just because the case or shell has broken away from the key blade. This top quality replacement 2 button remote key shell will allow you to swap over the remote module and transponder chip from your broken key to a new case and once the blade it cut to match you will essentially have a new key.

Please note the transponder chip in this type of key is usually super glued into the shell and so great care should be taken when swapping it over in to the new shell. If you damage the transponder chip and you do not have another key it can be a very expensive exercise.

To open the 2nd generation key shell you will notice a small slot in the case on the key ring loop. It measures about 6 mm wide. Using a small flat blade screw driver, place the bade of the screw driver in this slot and gently twist it and the case will pop open.

We generally clone the transponder and place the cloned chip into the new shell leaving the old chip in the old shell to avoid any issues. This old key can then be kept as a spare to copy from should you lose the new one.

If you come into our East Victoria Park shop we will be happy to cut the key, clone a new chip, swap over your case and test your battery, while you wait. It is always best to have the car present when getting the key cut so it can be properly tested. 

WE CHARGE $50 TO CUT THE KEY, CLONE THE TRANSPONDER AND TRANSFER & TEST THE REMOTE, CHECK BATTERY AND CIRCUIT BOARD TO ENSURE IT IS TRANSMITTING CORRECTLY - THIS SERVICE IS ONLY AVAILABLE AT OUR EAST VICTORIA PARK SHOP IN PERTH W.A.

If you do not live close by you can of course order this key shell and take it to your local key cutting shop and have them cut the blade to match your existing key. Then you can swap the remote module into the new shell and you are up and running.

There are lots of cheap key shells on the market and we have tested lots of other brands but this key shell made by JMA from Spain is definitely the best quality replacement we have tested. The machining of the key blade is very exact and so the key works well once it is cut correctly. A variance of even as little as 0.01mm can make a huge difference to how well a key works and so it is vital to get your key cut at a reputable key cutter who regularly calibrates their key machine.

REF - MLTOYO-15.P5