Holden VE Commodore 3 button flip or fixed blade key remote case replacement

We know it can be very frustrating when the button pad on your key crumbles and so it is difficult to press the button to lock or unlock the car. You don't need to worry or think that you must replace your entire remote.

Here we offer you a top quality replacement remote case so that you can transfer your remote circuit board into this new case and re-attach it to your key part.

Button symbols on this case are - LOCK - UNLOCK - BOOT on the front and red PANIC button on the back. The case also included the metal end to which you attach your key ring.

The part is made by JMA who are one of the leading makers of keys and key parts in the world. Based in Spain they make high quality replacement key shells and cases that work well and fit well with the original OEM parts.

To separate the remote part from the key part, place a flat blade screw driver in the slot across the back of the remote. Gently press it down and twist and the 2 sections will come apart. 

Now if you look at the end that was inside the key part you will see a small 5 mm wide slot. Again carefully place a small to medium flat blade screw driver in this slot and twist. This will lift the button pad off the rest of the remote.

It is always a good idea to test the battery as you have the remote open anyway. This can be done using a multi-meter if you have one. 

The change over is pretty easy to do yourself or come into our shop in East Victoria Park and we will swap them over for you, test the battery, clean the circuit board and check that the transmitter is functioning correctly afterwards.

Please note we do charge a fee for this service of $20.

CODE: MLGM01