Mongoose M80 Series N4096 Z333 3 button car alarm remote control MRC83R

This genuine Mongoose MRC83G 3 button car alarm remote works with a number of different M80 series car alarm, central locking or immobiliser systems manufactured after 2011 It operates on 434 MHz and has a RED LED.

Earlier model M80 systems made from mid 2009 to 2011 were supplied an identical looking 3 button remote control with a GREEN LED which operates on 303 MHz.  

The circuit board of this remote will have the following letters printed on it - UTDD. The LED colour will tell you which remote you need.

The remote has no model number on the case and there are other very similar looking remotes on the market that are not the same so it is vital you check what system is fitted to your vehicle before purchasing this remote.

The back cover of the remote just has the N4096 Z333 compliance number on it.

If you do not have a working remote you will need to find your over-ride code from the owners manual.

Below you will see the coding instructions for the the M80 systems that this remote can be used with.

WARNING! KEEP BATTERIES OUT OF REACH OF CHILDREN. Never allow children to replace button batteries on any device. Swallowing or placing a button cell battery inside any part of the body may lead to severe or fatal injuries in as little as 2 hours or less due to chemical burns and potential perforation of the oesophagus.

If you suspect your child has swallowed a button battery or placed inside any part of the body, immediately call the POISONS INFORMATION CENTRE on 13 11 26 for prompt advice. If your child is having any difficulty breathing, contact 000.

Dispose of used button/coin batteries immediately and safely. A battery can still be dangerous even when it can no longer operate the device. Place sticky tape around both sides of the battery and dispose of it immediately out of reach of children in an outside bin or recycle safely.

Please see button battery safety information from the Australian Competition & Consumer Commission (ACCC).

To learn new remotes to M80 models:

1. Disarm by existing remote, or use the override
2. Open the drivers door and leave open, LED starts Flashing
3. With-in 10 Seconds, Turn the ignition ON - the LED will now light Solid for 10 Seconds
4. With-in 10 Seconds, turn ignition OFF then back ON
5. The LED stays on &the Siren chirps 3 times to confirm remote code learning mode
6. Press arm button on first remote (siren chirps once to confirm)
7. Press arm button on second remote (siren chirpstwice to confirm)
8. Repeat for any other remotes
9. To finish, turn the ignition off or Wait 10 seconds for learning process to complete, siren chirps quickly 3 times