Toyota Camry 2018 onward genuine Denso 14FBC proximity remote 89904-06220

Toyota Camry 2018 - 2020 models compatible 3+1 button proximity key or smart key with the part number 89904-06220.

On the back of the genuine key you will see:

CAMRY
FCC ID: HYQ14FBC
IC: 1551A-14FBC
IFT RLVDE1415-0439
MODEL: 14FBC
DENSO

You may find other models also feature this detail on the back of the key case and so to be absolutely certain this key is the same as your key you should check the circuit board number inside.

To do this carefully remove the emergency key blade. Inside the section where the emergency key is fitted you will see a little slot that the end of the emergency key will fit into. Position the end of the emergency key in this slot and twist to open the case. Once the case is open you will see the circuit board. There is a black plastic cover over the front of the circuit board as shown in the attached photos. Gently lift this plastic cover at the end where the little LED can be seen and you will see the circuit board number.

The circuit board number for this remote is: 231451-0351

On the front of the circuit board is a plastic cover. Very gently lift this and you will see the circuit board number at the top near the LED.

This key is designed for the Australia market and the remote transmits on dual frequency 312/314 MHz FSK.

The key uses the ID-8A H-CHIP transponder type.

As with all genuine Toyota proximity keys there is no emergency keyblade included but you can add one from the compatible items tab. 

The new key comes with a battery already fitted and a spare battery can be added to your order from the Compatible Items tab also. 

These keys must be programmed to the vehicle using a diagnostic tool plugged into the vehicle.

Many Toyota models after 2018 require a special rolling code security pin code which changes every 30 minutes. This makes programming a spare key more difficult.

We charge $170 to code this type of smart proximity key which requires this special pin code and cut the key blade if we supply the proximity remote key.

We charge $90 to code this type of smart key and cut the key blade if we have supplied the remote and key and the vehicle does not need a rolling code security pin code. 

You will need to call to make an appointment and we will need the vehicle for approx 45-60 minutes.

We are licensed to do this or you can take the key to the dealer or a licensed locksmith near where you live.

To program the new key and cut the new emergency key blade we will need th evehicle for around 45 minutes and you can book an appointment on (08) 6110 2693.

WARNING! KEEP BATTERIES OUT OF REACH OF CHILDREN. Never allow children to replace button batteries on any device. Swallowing or placing a button cell battery inside any part of the body may lead to severe or fatal injuries in as little as 2 hours or less due to chemical burns and potential perforation of the oesophagus.

If you suspect your child has swallowed a button battery or placed inside any part of the body, immediately call the POISONS INFORMATION CENTRE on 13 11 26 for prompt advice. If your child is having any difficulty breathing, contact 000.

Dispose of used button/coin batteries immediately and safely. A battery can still be dangerous even when it can no longer operate the device. Place sticky tape around both sides of the battery and dispose of it immediately out of reach of children in an outside bin or recycle safely.

Please see button battery safety information from the Australian Competition & Consumer Commission (ACCC).

GEN REF: 89904-06220

MK REF: MK6075-22248