Toyota proximity key circuit board 0140B 314.35 MHZ FSK 4D DST80

This product has been temporarily removed from sale as direct result of the Consumer Goods (Products Containing Button/Coin Batteries) Safety Standard 2020 which becomes enforceable on 22nd June 2022 and carries fines of up to $1million. 

All products that contain a button cell or coin type battery must be safety tested to confirm they comply with these new regulations. All button cell batteries must be in a new type of packaging with new labels. 

We are working with all of our suppliers to confirm this compliance before we make the product available for sale again. 

We should have had 18 months to get this compliance but sadly the ACCC did not inform our suppliers or us or pretty much any other industry and we only found out about this new law 4 weeks ago.

Please feel free to email us with the details of what you were looking for and we will give you an update on when we expect it to be back available for sale.

This very high quality remote circuit board can be used with a number of Toyota & Lexus proximity keys. It features 4 buttons but using our equipment in store it can be configured in a number of ways to suit your vehicle even if you only have 2 or 3 buttons on your current remote.

Compatible with proximity keys where the circuit board number is: 271451-0140 with an ID4D DST80 proximity transponder and transmitting on frequency 314.35 MHz FSK as shown in the main photo.

Can be used as an alternative to the following genuine part number:

89904-30270 - Lexus ES IS LS GS 2006 - 2008 - HYQ14AAB
89904-48100 - Toyota RAV 4 or Kluger - HYQ14AAB (BLACK SHELL)
89904-33181 - Toyota Camry - HYQ14AAB (SILVER SHELL)
89904-48160 - Toyota Kluger 2008-2011 MDL B56EH (SILVER SHELL)

You can check under compatible items to see which keys this board is compatible with but this may not show them all so the most accurate method is to open your remote and check the number printed on your circuit board.

WE DO NOT SELL THIS ITEM ONLINE AS IT CAN ONLY BE CONFIGURED USING SPECICFIC TOOLS HERE IN OUR WORKSHOP

These types of keys can only be programmed to a vehcile using diagnostic equipment conected to the vehicle by a licensed technician. We are licensed to do this work and have a workshop in East Victoria Park.

This type of job usually takes around 45 minutes to complete so please call us on (08) 61102693 to book an appointment.

WARNING! KEEP BATTERIES OUT OF REACH OF CHILDREN. Never allow children to replace button batteries on any device. Swallowing or placing a button cell battery inside any part of the body may lead to severe or fatal injuries in as little as 2 hours or less due to chemical burns and potential perforation of the oesophagus.

If you suspect your child has swallowed a button battery or placed inside any part of the body, immediately call the POISONS INFORMATION CENTRE on 13 11 26 for prompt advice. If your child is having any difficulty breathing, contact 000.

Dispose of used button/coin batteries immediately and safely. A battery can still be dangerous even when it can no longer operate the device. Place sticky tape around both sides of the battery and dispose of it immediately out of reach of children in an outside bin or recycle safely.

Please see button battery safety information from the Australian Competition & Consumer Commission (ACCC).