Elsema Penta PCR43302RE 2 channel receiver & 2 X PCK43302 remotes

The older Elsema FMT-301, FMT-302, KEY-301 & KEY-302 remotes are now dis-continued. This receiver kit can be used either in tandem with your existing older Elsema receiver or to replace it.

If you have a large number of the older 27Mhz remotes and wish to continue to use those but need to get more remotes then why not have this receiver wired in tandem with the existing receiver so you can start using the new PentaCode 433MHz PCK43302 2 button remotes while still using the remaining work older 27MHz remotes.

Once all of the older 27Mhz remotes have died you can remove the old 27MHz receiver and just use 433MHz remotes like these.

This kit comes with 2 remotes included and additional remotes can be added to your order from the Compatible Items section below.

The PentaCode PCK43302 remotes use a 12 dip switch code so the code can be changed as needed which suits larger sites that wish to be able to change the codes periodically.

This Elsema PCR43302RE receiver is compatible with either Elsema PentaFOB and PentaCODE remotes and is fitted in an enclosure.

It has 2 relay outputs which can be switched “on” and “off ” independently. The relays are capable of switching loads of up to 10 Amps at 240 Volts AC.

The receiver is small and can be easily installed into your existing automatic gate opener or garage door controls. Other applications include light control, security shutters or anywhere else you need a wireless signal to transmit a contact closure.

This receiver is supplied in an enclosure which can be screwed to the wall but is not weatherproof and so should not be fitted where it might be exposed to rain.

The PentaCODE® dual coding system gives the installer the option to use the classic 12-way dip switch coding with Pentacode remotes or one of over 17 billion encrypted codes and the PentaFob remotes.

With the 12-way dip switch, just match the Pentacode keyring remotes and the receiver's dip switch and it's coded.

With the encrypted code you switch all the 12-way dip switches OFF and the remote and receiver automatically goes into the encrypted coding.

Please see coding instructions for encrypted coding procedure if you wish to use the PentaFob type remotes.

The receiver is covered by a 2 year manufacturers warranty.

PCR43302RE RECEIVER SPECIFICATIONS:

Supply Voltage: 11.0 – 28 V AC/DC. Can use Elsema DC or AC power supply, 12PP1000 or 24PP.
Current Consumption: 21 mA standby
Operating frequency: 433.100 to 434.700 MHz
Sensitivity: Better than 0.316µV (-117dBm)
Relay Output: Two change over relay output, rated at 8 Amps /240V AC
Antenna: Elsema ANT 433MHz series
Enclosure Dimensions: 110 x 68 x 32 mm
Useable Transmitters: All Elsema type PCK433 & FOB433 series
Ideal for garage doors, automatic gates or switching most device